SierraMtns
ArboristSite Operative
I went out to setup up my new 3120 and run it for awhile to break it in. I put on a 32" bar and fresh chain and hit some logs. I noticed that it kept hitting the rev limiter. Not sure what that is set at but it seems like around 9,500 which seems really low. I did a couple cuts but didn't seem to be running well. Not sure if this is normal? I did a short video to show how it was acting.
What do you guys think? Normal? Its going to be running a 50" bar and 404 chain for milling.
Thanks
What do you guys think? Normal? Its going to be running a 50" bar and 404 chain for milling.
Thanks