jmatteau
ArboristSite Member
Hi all,
I have been tinkering with an 026 that sat for a few years, would not run before that. I broke it down, P&C look good, all sealed etc. Cleaned and rebuilt carb, new inpulse line, new fuel line, new plug, New filter, fresh gas. Carb has H,L and Idle. Turned out H and L 1.25 turns, saw fires up, Can tune the L and H, runs WOT Great, will idle super fast but I cannot get it to idle correctly. I will get it as slow as it will go before it stalls and the chain is still spinning pretty fast. Also, if I engage the chain brake it stalls right out.
Any ideas what else to look for or try? Thanks for any ideas!
I have been tinkering with an 026 that sat for a few years, would not run before that. I broke it down, P&C look good, all sealed etc. Cleaned and rebuilt carb, new inpulse line, new fuel line, new plug, New filter, fresh gas. Carb has H,L and Idle. Turned out H and L 1.25 turns, saw fires up, Can tune the L and H, runs WOT Great, will idle super fast but I cannot get it to idle correctly. I will get it as slow as it will go before it stalls and the chain is still spinning pretty fast. Also, if I engage the chain brake it stalls right out.
Any ideas what else to look for or try? Thanks for any ideas!