031 new one on me?????????????

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Phil_C

Phil_C

ArboristSite Operative
Joined
Dec 24, 2009
Messages
449
Location
Australia
It is a bit hard to tell from the pictures if there is any deep scoring of the cylinder between the port and the head of the cylinder. I can see some marking there but can't tell how deep it is. There is a couple of lumps below the port, are they carbon or metal lumps? What does the piston look like? Does it have any scoring down the side? Have you done a compression test on the saw? I'd hate to see you throw away a serviceable cylinder:)
What diameter is the bore? I have a 44mm piston and cylinder in good condition.

Regards

Phil
 
southbound

southbound

ArboristSite Guru
Joined
Oct 14, 2008
Messages
861
Location
tn
I was cleaning it up..I did not want anything getting in the way of the new points...

Actually I was tightening the flywheel nut when I noticed the smears....
 
glock37

glock37

Addicted to ArboristSite
Joined
Jun 7, 2009
Messages
1,806
Location
Monroeville,Pa
doesnt stihl have one of the atom units

Last time I ask the stihl dealer there still available

But i think you cant use them on the 031 if I remember right

the unit has a Stihl Number about 15 to 25 bucks
 
southbound

southbound

ArboristSite Guru
Joined
Oct 14, 2008
Messages
861
Location
tn
Ok the P&C showed up today.. I took some pic's before I clean them up a little...

DSC04531.jpg


DSC04540.jpg


DSC04539.jpg


DSC04533.jpg


Not bad a P&C and new set of rings $40....
 
southbound

southbound

ArboristSite Guru
Joined
Oct 14, 2008
Messages
861
Location
tn
Man I just got in with a set of gauges.. I must have lost mine.....

I also am supposed to make a how to to mod a muffler on a 290,310,390 type saw tonight....

We will see what happens.....
 
southbound

southbound

ArboristSite Guru
Joined
Oct 14, 2008
Messages
861
Location
tn
Well I found a few things missing..

The little clip for the throttle linkage....

muffler gasket......

one spark plug.....

Will know more latter.....
 
southbound

southbound

ArboristSite Guru
Joined
Oct 14, 2008
Messages
861
Location
tn
Thanks Fish...

Looking at the IPL I don't see a muffler gasket???

Should there be?????????

And can anyone give me the Bosch plug number???

Thanks!!!!!!!!!!!!!!!!
 
southbound

southbound

ArboristSite Guru
Joined
Oct 14, 2008
Messages
861
Location
tn
Ok so I went out to my bench and found the missing clip....

I also went without the muffler gasket till I found out if it needs one....

So anyway it is all back together and as soon as I can we will see if it runs.....

Thanks ths far for all your help!!!!!
 
southbound

southbound

ArboristSite Guru
Joined
Oct 14, 2008
Messages
861
Location
tn
ok so no spark!!!!!

Here is what I have done...

New plug wire....

swapped points and gaped to .015....

Wima

and new P&C..

any idea's?????

Thanks.........
 
Top