.....
I put my 346 to one piece earlier and went to run it a little.. Worked nicely.
...
With original cylinder buying Meteor piston might be option. For example
http://www.ebay.com/itm/Husqvarna-M...866?pt=LH_DefaultDomain_3&hash=item27de8a6722
I use the same for about 2 years now , no problem , dont forget the vacuums testsThat site doesn't give much information from parts. Picture of piston seem to be same for every model. But I don't mean they can't be good and useable parts.
Meteors have good reputation here and partly due to that I have put them both my saws. But visually piston from 40$ chinese cylider I odered (and got badly scored due to lean tune..) kit looks fine too.
Btw. I got my spark plug pressure adapter today. Now my test kit is quite complete. For start at least.
View attachment 412868
Tested it to my 350. Leaks very badly. Rebuild needed again
change the plastic tighter in the intake boot to the 350 with a metal , common problem leaks from this plasticsThanks for the information - I will buy the Meteor then ... .
Good luck with your 350 repair ... .
change the plastic tighter in the intake boot to the 350 with a metal , common problem leaks from this plastics
picture if you canGot metal clamp allready. And new crank seals. But main leak is at cylinder adapter. I used some HT silicone there and I think it hasn't last fuel. There may be bad thread in adapter too and I'm not sure if I can use it anymore.
yes use dirko , yamabond , hondabond, threebond, no problem with thems
Enter your email address to join: