371xp problems

[rvz]

Owned for a few years now. When I fill the tank and start cutting the saw stalls after a half dozen cuts through 20" or so. I burp the tank and it starts right up. As the tank gets more empty the saw lasts longer between stalls.

Last week same problem but on a hot day it gave out and would not restart. Any help on the possible issue would be appreciated.

Thanks, Rick

 

[romeo]

Sounds like your tank vent is plugged.

 

[THALL10326]

Owned for a few years now. When I fill the tank and start cutting the saw stalls after a half dozen cuts through 20" or so. I burp the tank and it starts right up. As the tank gets more empty the saw lasts longer between stalls.

Last week same problem but on a hot day it gave out and would not restart. Any help on the possible issue would be appreciated.

Thanks, Rick

You got a tank vent issue. No air going in the tank means no fuel coming out. Replace your tank vent and problem should be resolved..

 

[THALL10326]

Sounds like your tank vent is plugged.

Yup yup...

 

[HiOctane]

It's a white"dime' located in a recessed area in upper part of your tank on clutch side.You dont have to remove anything to replace it.

 

[rvz]

Thanks all

I will check into that.