telemaster
ArboristSite Member
Hey guys,
I am working on a bit of a frankensaw and have a few questions.
I am going to bore out a cylinder to take the 52mm big bore piston for the 372. The first question is what should I have the cylinder bored to? If the piston is 52mm, would I bore to exactly 52mm or a thousandth(s) over?
Never done this before and looking for some advice.
Also, does anyone have a con rod for a 372 that they could measure the ID of the wrist pin bearing hole? I need to know how big the hole in the con rod needs to be to accept the wrist pin bearing.
I know these are specific questions with out much other detail, but I promise to post pictures of the completed project once done. I think it is going to be pretty freakin' sweet!
Thanks in advance.
I am working on a bit of a frankensaw and have a few questions.
I am going to bore out a cylinder to take the 52mm big bore piston for the 372. The first question is what should I have the cylinder bored to? If the piston is 52mm, would I bore to exactly 52mm or a thousandth(s) over?
Never done this before and looking for some advice.
Also, does anyone have a con rod for a 372 that they could measure the ID of the wrist pin bearing hole? I need to know how big the hole in the con rod needs to be to accept the wrist pin bearing.
I know these are specific questions with out much other detail, but I promise to post pictures of the completed project once done. I think it is going to be pretty freakin' sweet!
Thanks in advance.