395 clutch on a 2095

[Husky372bbported]

I have 2 395s that are parts saws now. Been usin a 2095 past few days at work and was wondering if running a 395 clutch be ok. Same size and all but different design

 

[RiverRat2]

If it measures the same as you say in each dimension and the tread pitch is the same I say go for it!!! I could use a good starter recoil assem. if you want to part with one

 

[Husky372bbported]

Ok and I got one for a 395. I think I pd like 100 for it brand new. You can message me and we can go from there if you want it. Also do you know if it would make it cut any different at all?

 

[RiverRat2]

Ok and I got one for a 395. I think I pd like 100 for it brand new. You can message me and we can go from there if you want it. Also do you know if it would make it cut any different at all?

It shouldn't cut any different, I would put it on and fit your Bar/clutch cover side and make sure it clears the inside & brake band by rolling the chain by hand. may have to build a couple small bar stud shims for between bar & cover but that should be no biggie will pm in a bit

 

[Husky372bbported]

Ok thank you. That's what I was thinking too