Run it 3 to 5 minutes wide open in the cut with out letting off the trigger that resets the computer.
Shoot Terry a message and ask him, some of the 2014's were updated but i'm not sure of date they began the update.
Well, mine has a pretty bad stumble off idle, and will sometimes die if I set it down for more than 30 (or so) seconds. I haven't checked to see which carb I have, but it is annoying as hell, and pretty much makes me hate running the damn thing.
I don't have a manual. Can anyone clue me in on how to fix this? Or is it just time for a new carb?
Run it 3 to 5 minutes wide open in the cut with out letting off the trigger that resets the computer.
Problem is it's usually hard for most to find something large enough to do this reset . 5 minutes in a cut is a long time !
Yes it is.Problem is it's usually hard for most to find something large enough to do this reset . 5 minutes in a cut is a long time !
My 2013-2260 had the EL-46. It now has the EL-48.As I recall it, the EL-48 replaced the somewhat troublesome EL-46 late 2012 (or very early 2013).
My 2013-2260 had the EL-46. It now has the EL-48.
I'd much rather run the smaller/lighter 562 than a 372 with a 20" bar.The lighter weight than a 372 appeals to me for running a 20" bar. The last 562 was a old one and I had ran great and I just sold my 2171 so I need a replacement.
I have a late 2014 562xp and it runs like a raped ape. Spent a year using it 7-8 hours a day thinning.. pretty hard on a saw..
Clutch went out a month or so after I got it, but it was under warranty so it wasn't a big deal.
Only real problem I've had is that after a 15+minute break when it's "lukewarm," its a real pain to start...
Yup I do that when it's hot. My saw has problems starting when it's not quite hot and not quite coldHave you tried the following for starting your saw when "hot"?
- Pump fuel purge bulb a few times
- Flip choke to upper position, then drop it back down to the middle (run) position
- DO NOT push in decompression valve
Pull 1-2 times.
Once I started doing it this way (especially NOT using the decomp valve for a hot start), my 562XP starts with 1 pull when warm/hot.
Enter your email address to join: