That was back when saws (and the operators) were built like tanks.On the other hand, saws AND boats, ran for many years w/non-detergent 30W at 20:1.............View attachment 919754
And 95% of the cars/trucks you saw were made in USA.That was back when saws (and the operators) were built like tanks.
And doubled as a Wasp smoker in a pinch.On the other hand, saws AND boats, ran for many years w/non-detergent 30W at 20:1.............View attachment 919754
I don't know much about any of this, so am asking, how would you get carbon from running this oilI suspect you're gonna get a lot of ash/carbon if you use TCW-3 in an air-cooled engine.
I don't think TCW-3 is made for the temperatures that air-cooled motors can get up to.
Higher temperatures in a non-water-cooled engine.I don't know much about any of this, so am asking, how would you get carbon from running this oil
in a non boat engine, and not have this carbon in the boat engine.
So sell it , everything is selling good right now with all that went on.I have gallons of HP left over from my boat.
It's still not the right oil for your saw.I have gallons of HP left over from my boat.
Nuff said!It's still not the right oil for your saw.
Enter your email address to join: