davefr
Addicted to ArboristSite
In my Husky 41 rebuild, I've encountered 4 bearings. (sprocket needle bearing, 2 crankshaft bearings, and a needle bearing at the connecting rod).
Should I manually lube any of these prior to re-assembly? Do the lower bearings get enough residual oil from fuel vapors or do they need a "get started" dose?
If any of these would benefit from assembly lube, should I use plain oil, undiluted 50:1 oil, or grease?
Thanks
Should I manually lube any of these prior to re-assembly? Do the lower bearings get enough residual oil from fuel vapors or do they need a "get started" dose?
If any of these would benefit from assembly lube, should I use plain oil, undiluted 50:1 oil, or grease?
Thanks