SmellyPirateHooker
ArboristSite Guru
OK, so I put the 8 pin driver on the cs620 (
7 was stock) and 24" bar. Results are interesting, really fast in the cut but slightly difficult to maintain cutting. Least In the 20" +oak round I was using. But there's an issue, 3/4 if the way through every cut chips jam it up, lodging between the chain and bar on the cutting side. Is this a chip removal issue where a full skip might help or a geometry issue? The chain angle on the bar ramps doesn't seem too out of spec to me. What do you guys think?
7 was stock) and 24" bar. Results are interesting, really fast in the cut but slightly difficult to maintain cutting. Least In the 20" +oak round I was using. But there's an issue, 3/4 if the way through every cut chips jam it up, lodging between the chain and bar on the cutting side. Is this a chip removal issue where a full skip might help or a geometry issue? The chain angle on the bar ramps doesn't seem too out of spec to me. What do you guys think?