- Joined
- Dec 6, 2014
- Messages
- 21,189
- Reaction score
- 25,058
What about that poor passage below the screen?
What about that poor passage below the screen?
The screen is not the problem, but the crud in the passage. The other passages in the carb have crud too.Limiter caps are off. The idle screw wont let it keep running no matter the setting, has to be full throttle, it will die on half throttle. I have not pressure/vac tested the saw yet. The screen wasnt letting all the light in, so I swapped that out. Anyone know the stock settings for the screws? I have been using 1.25 out on L and 1.75 on the H.
Are you referring to Pic on post #15 or screen not letting / showing enough light - post #20 or am I missing something? I am looking for answers for two different projects and am"Trying" to interpolate the relevance of this postWhat happened to the post about the screen being blocked?
What happened to the post about the screen being blocked?
Enter your email address to join: