- Joined
- Nov 9, 2005
- Messages
- 1,539
- Reaction score
- 1,817
This little Poulan Pro s25 belonged to dad, he's been dead 20 yrs and didn't run it for a few years before that. I pulled it out of the shed, pulled off the top, will need a breather. While I had it open, I put some mix in the carb and it run on the second pull. I think it'll be fun to clean it up and get it running.
This one I found and it followed me home, $20. Start rope was only about 14" long so I replaced that, wasn't oiling the chain, but was putting out oil behind the bar and dripping off the bottom of the saw. The oiler tube was misplaced and it works fine since I fixed. The chain and bar is toast, bar is .058 and chain is .050. I put a 20" 0325 NK bar and chain on and it cuts pretty good. Will add pictures in next post.
This one I found and it followed me home, $20. Start rope was only about 14" long so I replaced that, wasn't oiling the chain, but was putting out oil behind the bar and dripping off the bottom of the saw. The oiler tube was misplaced and it works fine since I fixed. The chain and bar is toast, bar is .058 and chain is .050. I put a 20" 0325 NK bar and chain on and it cuts pretty good. Will add pictures in next post.