Stihlverado
Addicted to ArboristSite
From we non-attendees, it was a sharp looking sign. :yourock:
+1!!:agree2:
From we non-attendees, it was a sharp looking sign. :yourock:
John have you messed with the GTG sign any? I sure do like it.
I put a coat of Watco on the front. Ran out, need to get some more. It brought out the grain pretty nicely. I will eventually hit it with several coats of satin polyurethane, I think. That should seal it up pretty well.
I put a coat of Watco on the front. Ran out, need to get some more. It brought out the grain pretty nicely. I will eventually hit it with several coats of satin polyurethane, I think. That should seal it up pretty well.
I get the bar and chains in the mail this week. I have a couple air filter covers if you need one, I'll get some pics of them tomorrow.
I received an original side-adjust 028 Super in the mail today, courtesy of Mr. Logging22! It has nearly perfect piston and rings, and is complete except for the air filter cover. Thank you , Les!
I already have it apart, and it seems to have need of some crank seals. I will try to borrow the seal puller from a a good buddy of mine. I may even do some repainting of the case. This dude has some compression, though I did not check it with a gauge. I'll post some pics of the process, as soon as I get that darn snap ring off the clutch cover. What a PITA when my snap ring pliers' bits are too small......
This looks like it will be a good saw, and a worthy project!
This is the "before" picture of chainsaw_hippie's new 028 Super. I stihl haven't been able to remove the clutch..... it is really on there.
OK.
Here are some of the needed parts:
4 AV mounts
Top cover (the original is rather torn up)
Crank seals
A lightly used air filter
Thought I'd try here before I went out on fleecebay....
I can get some Caber rings pretty cheaply, so that is basically all i need. The seal puller is on the way, will arrive probably Thursday. The piston and jug are enjoying an extended medicinal soak in a can of Berryman's, as there is a bit of carbonaceous googe built up there.
The bearings feel pretty nice. I think this saw will do well when it is back together. Gotta get the carb in the ultrasonic at some point.
Hope you guys are doing well!
OK.
Here are some of the needed parts:
4 AV mounts
Top cover (the original is rather torn up)
Crank seals
A lightly used air filter
Thought I'd try here before I went out on fleecebay....
I can get some Caber rings pretty cheaply, so that is basically all i need. The seal puller is on the way, will arrive probably Thursday. The piston and jug are enjoying an extended medicinal soak in a can of Berryman's, as there is a bit of carbonaceous googe built up there.
The bearings feel pretty nice. I think this saw will do well when it is back together. Gotta get the carb in the ultrasonic at some point.
Hope you guys are doing well!
Any updates on the 028 Teach?
Enter your email address to join: