sleepyweasel
ArboristSite Lurker
I recently purchased a cs530 from the trading post. It is set up with 18" .325 b&c. The bar is pretty worn, so i am thinking of replacing it. Either 18" or 20"
I plan to mm and pull the limiters.
My other echos cs-310 and cs-370 all are .375 .050 lp set ups.
It would be nice to be able to swap bars between the saws, is there a reason not to go 3/8 or3/8 lp on the 530?
The sprocket rims confuse me also. Which size do i need? Will the 3/8 one work with lp and full size 3/8?
If switching from .325 to 3/8 or3/8lp should i go up a tooth?
Special tools for swapping rims?or will a dealer do this for a resonable fee.
I plan to mm and pull the limiters.
My other echos cs-310 and cs-370 all are .375 .050 lp set ups.
It would be nice to be able to swap bars between the saws, is there a reason not to go 3/8 or3/8 lp on the 530?
The sprocket rims confuse me also. Which size do i need? Will the 3/8 one work with lp and full size 3/8?
If switching from .325 to 3/8 or3/8lp should i go up a tooth?
Special tools for swapping rims?or will a dealer do this for a resonable fee.