Filling up

[Trigger-Time]

I posted this on the milling side also, thought mite work
for someone on this side also

Here are a couple of small Ideas, that makes
refilling pre-mix & Bar oil less messy. I bought one of those NO-SPILL
gas cans, have put over 10 gallons of pre-mix through it and
I really like it, put the nozzle in the tank, push the button, let off
and your refilled, with out spilling fuel all over the saw. When
milling it can be harder to refill the bar oil. I was going to get one
of those quart gear oil jugs with the hose, didn't want to be refilling
the quart jug all the time and its lid would not fit my gallon bar oil jugs.
Was at the store and seen this thing with adapters to fit all sizes
of the plastic gas cans, I thought I could pour a full jug of bar oil
in a gallon gas can, But didn't need the adapters, it fit on the
bar oil jug.

I forgot to tell the oil jug, has a twist on and off, shut off

See pic below

Gary

 

[ciscoguy01]

nice

Dude, that's nice. where'd you pick that baby up? I spill more than I get in the saw sometimes...

 

[Trigger-Time]

where'd you pick that baby up? ...

Wally-World :blush:

Gary