I bought a 028wb and a Mac 1010 at a "junk" store this afternoon. They just begged me to buy them. The Stihl jug looks good, compression is 120 with a automotive tester that I can't thread all the way in the cylinder because it hits the piston. I put a kit in the carb, adjusted the coil with a business card, new plug, It has good spark, and it popped the third pull, it just will not "catch and run, it splutters for a second or two and dies. I'm dumb as dirt on this thing so where to start after what I have done so far, things to check, anything, I put a new fuel filter on it also and set the carb jets one full turn out each. Help me out here please.
Help with my new old Stihl, please
- Thread starter bobbyb13
- Start date
Help Support Arborist Forum:
Lakeside53
Stihl Wrenching
Check your fuel hose and Impulse hose... the just fall to pieces after a while. Check your carb inlet screen.
Do a quick search on AS - there is tons of info on resurrecting 028's and simialr..
Do a quick search on AS - there is tons of info on resurrecting 028's and simialr..
begleytree
H. sapiens moderatus
have you checked the choke? may be nothing but the choke is in the air filter and a little wire loop is what pushes it closed. had this one once, looked like it was choked, but removing the air filter and choking it with my finger over the carb made it fire right up and run (after removing improvised choke plate (aka, finger) fine. replaced the air filter and she still runs today.
-Ralph
-Ralph
Fish
Tree Freak
If your fuel mix is fresh, and it does as you have described, I would suggest looking at the points a little closer.
