Hey Sawtroll.....

[J.W Younger]

Wendell's saw runs very good.

Sure sounded good, I'm like a little green...
with envy.

 

[wigglesworth]

Which was when mine was probably 1/2 turn too rich on the H needle:tongue2: Aren't you kind of young for Alzheimer's to be setting in?:msp_wink: I'll take a 25-30% gain any day of the week!

Oh bologna... 1/2 turn? No way!

I was down around 800rpm fo sho....

 

[wendell]

Sure sounded good, I'm like a little green...
with envy.

Well, at least you'll get to run it in 3 weeks. :msp_thumbup:

 

[wigglesworth]

I accidentally sent it with semi-chisel so that is my fault but I thought he was going to put on same fancy-dancy chain he had made up.

We was gonna put my B&C on ur saw, and We tried to get the clutch off of mine, but was afraid we were gonna break it. I'm gonna order the correct tool this week. I'm gonna do some official "testing"

 

[blsnelling]

We was gonna put my B&C on ur saw, and We tried to get the clutch off of mine, but was afraid we were gonna break it. I'm gonna order the correct tool this week. I'm gonna do some official "testing"

I welcome a fair challenge anytime.

 

[wigglesworth]

I welcome a fair challenge anytime.

Me too!!

In all fairness, ur saw was stronger, no doubt.

That said, a properly filed and set up 3/8 chain is the way to go on any saw with enough balls to pull it. A stock 346 has the balls no doubt!!

 

[J.W Younger]

Me too!!

In all fairness, ur saw was stronger, no doubt.

That said, a properly filed and set up 3/8 chain is the way to go on any saw with enough balls to pull it. A stock 346 has the balls no doubt!!

Yeah, like square filed and the side plates stoned
and stuff