Husky 353..minor problem/question.

[Universe]

Saw starts, runs and performs beautifully. After its been used and warmed up, I'll place it down and pick it up after 10-15 minutes upon which it will start but will only go to about 1/2 throttle until it seemingly bogs out. About 2 minutes of fiddling with the throttle trigger it seems to work normally again. Filter is clean. Any suggestions? My buddy works at the saw shop so I'll get him to check it, but thought I would run it by the pros first, thanks

 

[Kenskip1]

Universe, Sound to me as if it is vapor locking. How old is the fuel mix? Possibly a lean setting on the carb. It could be just plane Heat soaked. After using do you let it idle to help disapte the heat? This could be the cause. Just my.02$ worth, Ken

 

[Universe]

I'll give that a shot. Fuel mix is fresh.

 

[SawTroll]

Have you checked the tank vent?

 

[Universe]

Haven't checked the tank vent, thanks.