Ol' Brian
ArboristSite Guru
Hey guys,
I think the oil pump on my 395xp isn't putting out as much oil as it should.
Any ideas on how much it should put out with the screw turned all the way to maximum? At the end of a tank of gas, it's only down about 1/3 to 1/2 tank of oil. I ran it today after finishing cutting with the bar off, and it is oiling.
Cleaned the bar, made sure the oil ports on each side of the bar are clear, and scraped out the channel. It did have quite a bit of gunk in it... don't know if that is a factor or not.
Any advice on what to check or ???
I think the oil pump on my 395xp isn't putting out as much oil as it should.
Any ideas on how much it should put out with the screw turned all the way to maximum? At the end of a tank of gas, it's only down about 1/3 to 1/2 tank of oil. I ran it today after finishing cutting with the bar off, and it is oiling.
Cleaned the bar, made sure the oil ports on each side of the bar are clear, and scraped out the channel. It did have quite a bit of gunk in it... don't know if that is a factor or not.
Any advice on what to check or ???