GENO-0506
ArboristSite Member
Ok,
Thanks all for the help with my ChainSaw, I practically rebuilt it, torn down now putting back but have question or any help you pro's can throw my way~!
OK,
I also posted in my original thread but thought this new one might get a quicker response!
so went to put it all together and I tried to pull the rope out of the spark plug hole that I used to stop the piston but being it was an old nylon rope thats been outside year, it was brittle and broke off! So the rest was stuck as was the piston, so I had to take it all apart!
There was a squeeze on rubber seal at the bottom connecting the hub showing the piston, can I buy rubber gasket stuff like that was on it if so what kind do I look for!
Second
When I put the piston back in, there is a ring that has to be squeezed in, is there a certain way to get the piston back in the upper shaft!
Do I lube or put oil all over before putting the engine and piston back together or can I spray with wd40 or equivalent!
Thanks for help!
Thanks all for the help with my ChainSaw, I practically rebuilt it, torn down now putting back but have question or any help you pro's can throw my way~!
OK,
I also posted in my original thread but thought this new one might get a quicker response!
so went to put it all together and I tried to pull the rope out of the spark plug hole that I used to stop the piston but being it was an old nylon rope thats been outside year, it was brittle and broke off! So the rest was stuck as was the piston, so I had to take it all apart!
There was a squeeze on rubber seal at the bottom connecting the hub showing the piston, can I buy rubber gasket stuff like that was on it if so what kind do I look for!
Second
When I put the piston back in, there is a ring that has to be squeezed in, is there a certain way to get the piston back in the upper shaft!
Do I lube or put oil all over before putting the engine and piston back together or can I spray with wd40 or equivalent!
Thanks for help!