Hybrid Build

[Adirondackstihl]

I bet that runs good with just a base gasket delete .Got a muffler Recipe figured out yet ?

Gotta take a look and see what's in the box o parts.
Might go triple on this bad azz

 

[Mastermind]

Maybe I'll start a new thread

Don't be a puzzy.

 

[glock37]

Ok the 044 / 046 hybrid is a nice upgrade without porting

How does the 064. / 066 hybrid compare ?




Sent from my iPhone using Tapatalk

 

[KG441c]

Couple nice ones in here today. 660, 064, 066 artic, 440 artic, 661r

 

[Stihlofadeal64]

View attachment 470326 Couple nice ones in here today. 660, 064, 066 artic, 440 artic, 661r

Paradise unveiled!

 

[Definitive Dave]

View attachment 470326 Couple nice ones in here today. 660, 064, 066 artic, 440 artic, 661r

I was gonna put an OEM polishing kit on the xmas thread but I guess you already found one
That will be a lot of nice hybrids when you get em all fixed
Dave

 

[Definitive Dave]

I'm not liking the looks of the Farmertec flywheel









I had to clean the ID threads so in the future this thing would be able to be pulled using the standard STIHL FW puller

pretty sure that will all buff right out, but I sent an OEM series 1 flywheel off a 10mm crankcase today, just in case

 

[KG441c]

I was gonna put an OEM polishing kit on the xmas thread but I guess you already found one
That will be a lot of nice hybrids when you get em all fixed
Dave

660 is sold. The 066, 066 artic, and 440 artic are for sale . Contact member JohnLaslab

 

[Deets066]

Maybe I'll start a new thread

For more banter? Or for the hybrid build?

 

[mcobb2]

Don't be a puzzy.

Ohhhhh he said the 'p' word!

 

[big t double]

But he kept it fresh with the z's

 

[mcobb2]

Tomato, ta-mato

 

[Adirondackstihl]

 

[KG441c]

Whats the transfer exterior wall look like Jeremy?

 

[Adirondackstihl]

Whats the transfer exterior wall look like Jeremy?

Haven't made it that far yet holmes

 

[KG441c]

Haven't made it that far yet holmes

Base looks very neat

 

[PA Dan]

Base looks very neat

Yes it does! I would like to know how much you took off both sides or what the jug measures to after you mill both sides.

 

[Adirondackstihl]

photo not found on my end. May be me...just checking.

I fixed it

 

[Adirondackstihl]

Base looks very neat

Thanks bud.
Roughed in with a DC Carbide burr and finished by hand with a Nicholson Mill Bastard file.

Took about 0.030-0.035" off each face.
Still have a bit further to go.
I need 2.3875" min to make it fit.
Gonna shoot for for 2.375". Should give me some wiggle room.

 

[mcobb2]

Bit*


Dumb@$$ engineer...