Haven't pulled the muffler but there is oil residue coming out the exhaust. I'm using sthil mix as all my other saws are sthil, and I shop there moreWhat kind of oil are you using? Have you adjusted the tune? What's the muffler look like, full of oil?
Not sure where to begin on adjusting the tuneHaven't pulled the muffler but there is oil residue coming out the exhaust. I'm using sthil mix as all my other saws are sthil, and I shop there more
It all looks good and has tons of fire it will light you up anywayInspect your plug cap and the spring that goes into the plug wire.
Will try in the morning.Rev it up while adjusting the H needle. Slowly bring the needle in while blipping it to wide open. When it goes from being rough sounding to fast, flat, and smooth, you then slightly back the H needle out until it is just on the fringe of sounding rough again.
Enter your email address to join: