I clean the saw really well: compressed air really helps. Remove the side and top covers, bar and chain, sprocket and clutch cup (on STIHL saws), and clean underneath.
This lets me inspect the saw so that there are no 'surprises' when I go to use it again. If I need parts, or something needs attention, I can get what I need.
It also removes any dry dust that can attract and hold moisture, and any greasy dust that can dry out and harden.
Clean the air filter, file the bar if needed, sharpen the chains, etc. reassemble.
Then I add a little Stabil to the fuel (if I have not treated the can) and run it dry. Try restarting 2-3 times.
Lately, I have also been draing the bar oil tank back into the jug (disposable paper funnels from gas station) instead of letting it leak out. Saves a mess more than anything.
Philbert
This lets me inspect the saw so that there are no 'surprises' when I go to use it again. If I need parts, or something needs attention, I can get what I need.
It also removes any dry dust that can attract and hold moisture, and any greasy dust that can dry out and harden.
Clean the air filter, file the bar if needed, sharpen the chains, etc. reassemble.
Then I add a little Stabil to the fuel (if I have not treated the can) and run it dry. Try restarting 2-3 times.
Lately, I have also been draing the bar oil tank back into the jug (disposable paper funnels from gas station) instead of letting it leak out. Saves a mess more than anything.
Philbert