MS440 oiler shaft O-ring

[jltrent]

I have tried several O-rings and none seem to work good. Anybody know the size and were to find. I have not checked the dealer yet as such a small order. Thanks

Those shafts are a pain to get in also.

 

[glock37]

Use grease make sure you use clutch washer when installing clutch
Stihl makes a driver when installing sleeve and seal all together


Sent from my iPhone using Tapatalk

 

[Ozhoo]

If you're asking about the o-rings on the control bolt, they are 4x2mm. Most places carry 4x1mm so you'll need to search around.

 

[jltrent]

I have 5 044, MS440 piles of parts and have just about all the parts to complete, but some of the oilers don't have the little O-ring on the end of the round shaft of the MS440 oiler. They are a pain in the azz to get in the crankcase, especially if you don't have the right O-ring.

That little rubber O-ring at the end of the shaft is what I need.

 

[jltrent]

If you're asking about the o-rings on the control bolt, they are 4x2mm. Most places carry 4x1mm so you'll need to search around.

That maybe it. Thanks

 

[Ozhoo]

Gotcha, no the one that seals at the case is 4x1.5mm