Hedgerow
HACK
Time to un-limit the transfers..Just unlimited the Carb on the 2166.
Oklahoma,AR,MO,KS,TX GTG (Next GTG 08/27/2016 ) Fort Scott, KS
- Thread starter Work Saw Collector
- Start date
Help Support Arborist Forum:
cobey
Addicted to ArboristSite
Thanks again Mike 
WKEND LUMBERJAK
Addicted to ArboristSite
So is it complete gutting of the inside haven't looked into it .
Morning midlanders.
Late morning everybody. Sun is finally shining and the wind is blowing. Have a good one....
Hedgerow
HACK
Yup..
Scoop em out deep.
Sun finally shining here. Water got up into my shop yesterday. Not horrible bad though. Mainly just wet concrete floor. Have to set up fans this evening to get it dried out for this weekends transmission swap on the Explorer.
Trotted thru the Mall's ignition but still no joy. Fuel runs out of the carb so a complete R & R of it is next.
cobey
Addicted to ArboristSite
I heard there was a lot of flooding in your area
cobey
Addicted to ArboristSite
I worked on a couple saws today.
Fixed the bar for the xl2 and put a
Super xl carb on my xl12 .
And other stuff
Went to chads for a carb kit
Today was a good day
Fixed the bar for the xl2 and put a
Super xl carb on my xl12 .
And other stuff
Went to chads for a carb kit
Today was a good day
Homelite410
Hack with a CNC Mill
I'd love to visit chad!
cobey
Addicted to ArboristSite
He is better today back to firing up saws and
Goofing off. Tarin was running around with a 4 foot
Bull snake...... good times. He had some carvings done too
back to firing up saws and Goofing off. Tarin was running around with a 4 foot
Bull snake...... good times. He had some carvings done too
WKEND LUMBERJAK
Addicted to ArboristSite
Rained most of the night, Good Sat. Morning to All.
Morning midlanders!
Morning everybody.Found this at a garage sale this morning. Poulan Countervibe. Not sure on the exact model but cylinder measures out to be 68cc. Model 4000, 4200, 4400? Thin ring. 20 inch bar, 3/8 full chisel. Nice shape.
Got up at 0 dark thirty to be up there in time. I was afraid sawnami would beat me to it.
Homelite410
Hack with a CNC Mill
Morning fellas. Working a Lil overtime today! Carry on.
Very good! You suck!
Found this at a garage sale this morning. Poulan Countervibe. Not sure on the exact model but cylinder measures out to be 68cc. Model 4000, 4200, 4400? Thin ring. 20 inch bar, 3/8 full chisel. Nice shape.
Got up at 0 dark thirty to be up there in time. I was afraid sawnami would beat me to it.
I'd like to run that against my J-red 670.
Only show up around here rarely in Craftsman guise.
Worked on a large oak (36" diameter) last night. Got half trailer load. Sharpened chains this morning and heading back. It is only a couple blocks from my house. Big trees have a lot of wood but they are a SOB to handle and move around without heavy power equipment, even after noodling into halves or quarters. Have a good one and be safe...
The big bore MS650 I have here would be fun to use on that. 32" x .404"
