Step by step porting

[little possum]

Thanks fellas!

Got my little poulan turnin 13500 and holding 10K or so in a 16" poplar with 18" bar. So far, everything is runnin smooth and it hasnt flown apart yet.

 

[pioneerguy600]

Thanks fellas!

Got my little poulan turnin 13500 and holding 10K or so in a 16" poplar with 18" bar. So far, everything is runnin smooth and it hasnt flown apart yet.

How far did you go on it?
Pioneerguy600

 

[little possum]

How far did you go on it?
Pioneerguy600

widened the intake and exhaust. Measured for 60% of the bore and probably ground to 65%

 

[pioneerguy600]

Very good,..what bar,chain and what are you cutting with it.
Pioneerguy600

 

[little possum]

Modified a little oregon bar to fit. .325 and 14" And one of Smilin Possums first attempts at a race chain.

I think I took some pictures.

 

[pioneerguy600]

Modified a little oregon bar to fit. .325 and 14" And one of Smilin Possums first attempts at a race chain.

I think I took some pictures.

Like to see them if they are not top secret.
Pioneerguy600

 

[cowboyvet]

Got my little poulan turnin 13500 and holding 10K or so in a 16" poplar with 18" bar. So far, everything is runnin smooth and it hasnt flown apart yet.

Do you think its good enough to take Terry at the next GTG? I'm hopin to have something to play with at the next one with any luck. Don't think I'll push one to hard on the porting as I abuse them pretty bad while carving.

 

[little possum]

I wish cowboyvet. Haha. I dont think its that hot, but Ill have to find another one for a stock comparison. But it was a good learner for porting cause I dont have a dollar in it and it ran... so I didnt see how I could go wrong.

 

[smilin possum]

Like to see them if they are not top secret.
Pioneerguy600

Jerry he thinks it's all top secret and he is eye balling my Stihl's pretty hard. He keeps this up I'm going to send him to you airmail. If I do send my boot back it may stihl be stuck on him somewhere.