Can't remember where this washer and eclip go. A diagram shows it going on the top of bearing but doesn't look right nor does the clip look big enough. Thanks.
O boy ... .. that's the w-i-d-e cage for use with the w-i-d-e spur sprocket setup.
You need the narrow cage to fit the drum you have.
Once you have the cage thing sorted out, the washer and clip will be a no-brainer.
I've hacked up your pic a bit .... the yellow X is the visible portion of the drum (the rest is under that plastic cover) ... the white X is the visible portion of the needle cage .... see how there's another row of needles peeking out of there?
They are all the original parts. I took it apart to check the CS seals and left it sitting long enough to forget how it went back together. One of those "simple" things, ya know? I had the drum figured out and if you would have said needle bearings than that would have clicked.
I popped the drum off and the cage went all the way in but I had to use lube otherwise it would push back out. The only groove is below the sprocket so the big snap ring doesn't have one?