dynomite76
ArboristSite Operative
Saw bogs when you first squeeze throttle then takes off cuts fine any suggestions?
Stihl ms 361
- Thread starter dynomite76
- Start date
Help Support Arborist Forum:
roostersgt
Addicted to ArboristSite
Tturn "L" screw clockwise 1/8th turn. or so, until saw gets "snappy" on throttle.
nmurph
ArboristSite.com Sponsor
- Joined
- Nov 26, 2007
- Messages
- 16,162
- Reaction score
- 7,166
Check the L screw. It sounds like it needs to be backed out a little. But it is possible that you are already against the limiter and they may need to be removed so the adjustment can be made.
There are some other possibilities, but this is where I would start.
There are some other possibilities, but this is where I would start.
SawTroll
Information Collector
Hardly clockwise.....
roostersgt
Addicted to ArboristSite
My bad. Got turned around. Thanks, and sorry for the wrong direction. Would have been an obvious mistake to correct. Turn the dang screw until it gets "snappy" off the trigger.
Log Splitter
ArboristSite Guru
The MS 361 also has an accelerator pump that gives a shot of fuel when the throttle is opened. If you can't get it to smoothly accelerate by opening up the L adjustment, then check out the pump.
dynomite76
ArboristSite Operative
Took out limiters backed out to 1/2 turn seems to be helping got dark before I could really see. On the limiters, I shave the side piece off stick back in but can I adjust again without taking them out? And now that they have been shaved will this keep them from backing out still? Thanks for all the help.
Similar threads
