gbsk
New Member
I have a Stihl MS290 chainsaw that a friend gave me. I am having a lot of trouble starting it. 3 chainsaw mechanics said it was fine. One guy said I need to push down the decompression valve located at the top of the saw. I looked everywhere and did not see one. Otherwise I tried to start it this way.
What I do is grab the handle, be sure to depress the safety switch on the top of the handle. Then I grab the trigger and push the vertical selector switch(stihl calls this the master control switch) on the saw, down to the bottom (fully choked) if it is cold. If it is warm move the selector switch up one position. Put the saw on the ground with your foot in the trigger handle. Put your left hand on the wrap handle and your right hand on the starter rope. Pull the starter rope slowly until you feel it engage. Then once you hear a pop, if you had a full choke move the selector switch up one notch. And keep cranking until the saw starts.
Why and how can I get this to start?
What I do is grab the handle, be sure to depress the safety switch on the top of the handle. Then I grab the trigger and push the vertical selector switch(stihl calls this the master control switch) on the saw, down to the bottom (fully choked) if it is cold. If it is warm move the selector switch up one position. Put the saw on the ground with your foot in the trigger handle. Put your left hand on the wrap handle and your right hand on the starter rope. Pull the starter rope slowly until you feel it engage. Then once you hear a pop, if you had a full choke move the selector switch up one notch. And keep cranking until the saw starts.
Why and how can I get this to start?