You need to take in all the details.
Sure is quiet in here....do I need to start a fight?
- Thread starter caleath
- Start date
Help Support Arborist Forum:
You need to take in all the details.
Time:
Get a lower hose heater........and some different PS fluid. Lol
It don't like it this cold!
I'm gonna check the fluid level tomorrow
Steering was sure stiff!
Oh BTW
Hey Rob!
Hey ADAM!!!!!
My heater was 600 w. The engine started SO much easier.
Easier on everything.
My heater was 600 w. The engine started SO much easier.
Easier on everything.
Just need to be able to pull it into the 75 degree shop and all would be good!
But the bosses frown upon that
I put mine in at -25.Just need to be able to pull it into the 75 degree shop and all would be good!
But the bosses frown upon that
Outside.
Truck warm. Cut hose and drain fluid and put one side of heater in.
By the second side the hose was too cold and stiff.
That quick.
Boil water in house and soak hose in the water.
Get it on. Tighten clamps. Fill say stem and burp.
Ahhhhhhh.
Much better.
Yeah. I should have done it sooner.
1* Merican and I still can't load a picture.
Must be something else.
Must be something else.
It's a heading your way Young Bison. Lol
You work nights?
40 Merican here right now
It's on the way Bucko!!!!!
Hey Dan
Hey Dan
Yeah we were near 50 'Merican yesterday.....wind....rain...fogg......lots of snow went away.....replaced with ice...+22 'Merican this AM..40 Merican here right now
It'll be short lived , 37 by Saturday
Day/Night Rob !
Day/Night Rob !
Night Dan.It'll be short lived , 37 by Saturday
Day/Night Rob !
Jimmy in NC
Addicted to ArboristSite
Morning all!!
Sent from my MiniMac running E-85!!
Sent from my MiniMac running E-85!!
-6 right now , not sure if its gonna warm up much today.
