Trigger-Time
Addicted to ArboristSite
Things are a little slow here so.
I'm going to build a small building about 12'X20' for my saw stuff.
would like to mill every thing I can. I was thinking about using
small dia. 5" to 6" post oak for floor joist and studs, milling two
sides of each log, so I end up with 3 1/2 inch thick joist and studs.
I know for the studs 24" OC will work, but what about the joist.
the joist would be running the 12' way on top of 4-4X6X20' CCA as skids,
then I can move it, if needed
I'm going to build a small building about 12'X20' for my saw stuff.
would like to mill every thing I can. I was thinking about using
small dia. 5" to 6" post oak for floor joist and studs, milling two
sides of each log, so I end up with 3 1/2 inch thick joist and studs.
I know for the studs 24" OC will work, but what about the joist.
the joist would be running the 12' way on top of 4-4X6X20' CCA as skids,
then I can move it, if needed