Has another ever used this? I saw it on a thread a week or so ago, and being that there's a listing on eBay that sells one for Walbro and Zama, $7 for the pair, I figured "what the heck".
I went to use it for the first time today, on a Walbro WA. I've done a few of these, and typically use a machinist's square to set the lever flush with the bottom of the chamber, as specified in the manual on the Walbro website. I set it with the machinist's square, and then went to check it with my new Walbro tool, and found that the tool was a good 1/32"-3/64" above a flush floor setting. I've always set levers based on manual specs, and never had a problem.
Has anyone else ever experience discrepancies between what the Walbro tool tells you and what the manual recommends?
I went to use it for the first time today, on a Walbro WA. I've done a few of these, and typically use a machinist's square to set the lever flush with the bottom of the chamber, as specified in the manual on the Walbro website. I set it with the machinist's square, and then went to check it with my new Walbro tool, and found that the tool was a good 1/32"-3/64" above a flush floor setting. I've always set levers based on manual specs, and never had a problem.
Has anyone else ever experience discrepancies between what the Walbro tool tells you and what the manual recommends?