![MVC-003F_43.JPG](https://proxy.imagearchive.com/99b/99b92516733b1b912645810502eaa96b.jpg)
With this done I'll work on putting the aluminum wall in.
![MVC-001F_57.JPG](https://proxy.imagearchive.com/ffc/ffc5b056c313bae0e64bed5ac349bb24.jpg)
With the bracing there was no way to get it in with 1 or 2 pieces. Ended up having to make 6 pieces. I'm using 3/16" aluminum sheet.
![MVC-002F_52.JPG](https://proxy.imagearchive.com/550/550b7a5d4f5b0e3a5e086cd1ac8b7096.jpg)
I'm cutting this freehand with a cut off wheel and angle grinder.
![MVC-001F_58.JPG](https://proxy.imagearchive.com/c66/c660ff8cdbc7f2f1b9692ebede812740.jpg)
Wall is in and now working on enclosing the backside for some out of the weather/eyesight storage. Cut some OSB so it self locks for a floor.
![MVC-002F_53.JPG](https://proxy.imagearchive.com/5fb/5fb1354fba7af93f05d7cff1a72a8fe5.jpg)
Cut some panels so they slide inside the back supports. The bolts for the upright wall and future back panel will keep them from sliding in.
![MVC-002F_54.JPG](https://proxy.imagearchive.com/edd/edd2079da3b26a1c2ca7c10dbe4fe484.jpg)
They will just lean out and lift up. Simple and secure.
![MVC-001F_59.JPG](https://proxy.imagearchive.com/fac/faca9f70da05377e3da137a679140087.jpg)
I just welded a small piece on the bottom edge and no way it can get over it when in positio
![MVC-001F_60.JPG](https://proxy.imagearchive.com/200/200bc9bb590bfeb76831eb1d22b1a73d.jpg)
Figured I'd make an easy grab handle and a spring loaded hold down for the access panel. Just drill a hole that was a little bigger than the small piece of pipe I had laying around. Then cut it in half and off.