New MS661 or 395xp, what do I pick?

[tdiguy]

yep, that’s what I did.

Initially anyway, I did later end up with Two 395XP’s

The 3120XP is a Beast of a saw, and Dave is an Excellent seller, neither have disappointed me. I would recommend or buy again from Dave without any Hesitation

Hi, I’m Doug, and I have a Problem,

Well actually, Two Problems,
My Garage isn’t BIG Enough, and
My BUDGET isn’t BIG Enough

Doug

I've been thinking about getting one from him for like 2 years.... I just can't see spending that much on a saw that would only get used occasionally at most. But if I didn't already have a 066, a couple big Echo's and a 7900 Dolmar, i would be all over it.

 

[toadman]

I am on the list for an 881 once they get released here... I have a big pile of 30-35" chestnut that I will mill with it. for now my 660 clone & 661 have been doing it, but it is very hard wood & I am at the point rather than ruin my saws just buy a 881

 

[weimedog]

Depends on you & assuming equal dealer support. Old school...394, New School 661 Both can make a lot of chips in a hurry.