Swap meet...

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
i need a 24" bar for a large mount husky and a tank for an ms440.got lots of stihl and husky parts to trade and a wee few dead presidents
 
Last edited:
If you could get one with just a nice cylinder, then I already have a "special" piston to use in your build, that will bump compression considerably (200 psi range.)

Jacob, any specs on that piston?
I have access to a lathe and a bridgeport collecting dust, and a stock 038magII i'm looking to beef up a little.Just looking at all options. Thanks Scoot
 
i need a 24" bar for a large mount husky and a tank for an ms440.got lots of stihl and husky parts to trade and a wee few dead presidents

I have a like new Husky 24" x .050 and a new Total Superbar 24" x .058. PM me if interested.

Always looking for 181/281/288 parts...
 
Mac Eager Beaver 2.3 wanted.

Mac. Eager Beaver 2.3" (38cc) wanted. Yeah, I know they are ugly.

A.K.A.: models E.B. 2316, E.B. 2318, Silver Eagle 2318, Mac 3818, Pro Mac 3805 and MacCat super 18. (probably others but you get the picture.)

Have Craftsman 36cc w/16" to trade. Model 358.350462 (I don't know which Poulan it is.) Works very good, cut up a coord of green walnut in September. Needs the fuel pick up line replaced someday.
 

Latest posts

Back
Top