GRTimberCO
ArboristSite Operative
I was feeling brave this afternoon so I pulled the muffler off my old Husqvarna 365 special. I clean off the exhaust port and lightly polished it with some fine grit sandpaper. Next I drilled a 5/16 hole on the right side to let it breath a little better. Now it wont crank. I tried adjusting the high and low on the carburetor but no dice. I did notice they were already both as far open (counter clockwise) as they would go before I moved them. I believe it is flooding because after it sits a few minutes it will crank and run at the high rev. Give it a little gas to let it idle down and she cuts off and won't crank back. Where do I go from here or is that going to be straight to the saw shop? Thanks
Last edited: