Hedgerow
HACK
Rats! the EPA are at it again :bang:
They're not as smart as they think...
:canny:
Rats! the EPA are at it again :bang:
I AM a dealer....lol. This is what my distributer just told me.
It could be, I have never had anything in the shop that needed one before.
Dave.
You may want to get a set... Sure beats taking them all the way out and cutting a groove in em' with a hacksaw...
Don't ask...
:msp_rolleyes:
I was wondering about thatAre the needle heads Splined, Double D, Single D? Chainsaw / Weedeater Carburetor Adjustment Tool Set
It just looks like a bare stud sticking out, but I can't see it well, it may be splined. Will have to pull the carb off for a better look.
Dave.
I was wondering about thatAre the needle heads Splined, Double D, Single D? Chainsaw / Weedeater Carburetor Adjustment Tool Set
Should be a Zama right?
Splined I'll bet...
The beauty of those is, once set, put the limiters back on, and the EPA dorks are none the wiser...
Think of it as "civil dis-obedience"...:msp_wink:
They have a Double D on the HS Needle. Regular Screwdriver for the LS needle.
No limiter caps at all on these saws.
Interesting read on this thread for sure.
The new 79'er sounds bada$$. Definitely gotta put one on my list.
I'm down to only 6 saws now, eventually I gotta get some more pigs in the pen.
I gotta get some more pigs in the pen.
if they did beef up the bottom I wonder how long it takes for them to come out with the 90cc version... Then how long will it take for someone to put the 90cc P&C on a non-beefed older bottom end and blow it up???Hum, I wonder why they beefed up the bottom end on them new 7910's?:msp_smile:
:arg:I may make it up to Specter's gtg in northern WI this August... I got a dandy 9010 for ya to run... Built like a tank and power to spare... VERY sexy saw...:msp_sneaky:
So I went to look at the 7910's new carb before I put the 7900 dual port muffler on to test. I see the highspeed is not adjustable with a screwdriver. I call up Dolmar and ask for the special tool needed to richen the carb and they tell me that we are not allowed by epa to have them.......
I will try that, I happen to have dual port 7900 muffler here right now, so I will just swap it out and see, Dave
I think the SLR system is all in the muffler, but I will need the screwdriver to richen up the high speed if I am going do the muffler swap. I have ordered the 4 tools to do this. I never needed them until now. I am going to borrow one locally so I can try it sooner. I have no idea why Dolmar Canada said you can't have the tool. They made it seem only the factory has them. I would have to be able to richen this saw up if I lived near the 4000 foot level.
Dave.
Meh, prolly not.....
I ran one in WI last week... Brand new though and not broke in... Nice saw, but less power than the 7900. I'm sure folks will find a way around that...
Enter your email address to join: