Can we count this one as a 'For' cylinder honing?
Do you always put your fingers out when holding the tool?
Got some good music going too, just need a glass of tea to top it off.
Another fine video production Mr. Randy!!
How do I get one of those split mandrels and that Wigglesworth thingy?
I was just teasing to see if I could beat the opposing sides out of the bushesNo, I never use a hone. The hone contacts the entire bore, and therefore, can remove plating where there is no transfer. This way you are just sanding where the aluminum is at.
Thanks for sharing, Randy. Good stuff as usual. So what was the attachment you used for your version of the Wigglesworth hone? Looks a helluva lot more effective than the eyebolt approach!
This is one of the best threads I have seen. It is so simple. I would spend hours cleaning with acid. This takes minutes!
So you use a nail to make the emry cloth older then you half the end so the cloth slides in? What do you use to half the nail?
I'm going to sea tomorrow until Tuesday afternoon. I'll give a call Wednesday morning to chew the fat while I drive to Philadelphia for business if that works.
Nice video, really. I'm floored every time I read something from you, always sharing and happy to do it.
Randy, once again, thank you so much. The knowledge you share is priceless. Thanks to treemonkey and wigglesworth too...
Enter your email address to join: