Mastermind
Work Saw Specialist
This ain't the first one of these I've done......but the first one was just last week. After doing a couple, I figured I'd share some of what I've figured out about em.
First thing I found was this strangeness.
From another angle...
And the case.....
OK, so you can see that the transfer inlet sticks down into the case......that would make it tough to cut the base on this jug. The case could be milled.......but I'm not gonna try that.
I did something else instead.
First thing I found was this strangeness.
From another angle...
And the case.....
OK, so you can see that the transfer inlet sticks down into the case......that would make it tough to cut the base on this jug. The case could be milled.......but I'm not gonna try that.
I did something else instead.