Good Luck with it.
Glockem45: Your Rakers are going to be aggressive when you get into the cut, so don't push the saw. You might even have to hold up on it a bit to keep it from grabbing too much wood, and bogging down.Sir does this mean you approve of my work?
I thought those rakers looked low too. He said he will run it tomorrow. Hes probably in bed now (early to bed and rise). He didnt get time to run it yet. He is an office jocky...sorry (ducks and hides) , i will now go put my asbestos suit on.Glockem45: Your Rakers are going to be aggressive when you get into the cut, so don't push the saw. You might even have to hold up on it a bit to keep it from grabbing too much wood, and bogging down.
Have you solved the tension problem yet ?
But your bar is still on upside down...
![]()
real men don't read the instructions.Hey that is what the manual says to do. It says flip the bar at every other time you fully sharpen the chain or swap chains.![]()
Just poking fun at you . Thats kind of a chainsaw joke. People point bit out all the time! Ha! Since there are so many who dont know that think it has to go the "right way" so you can see the writing correctly.Hey that is what the manual says to do. It says flip the bar at every other time you fully sharpen the chain or swap chains.![]()
Just poking fun at you . Thats kind of a chainsaw joke. People point bit out all the time! Ha! Since there are so many who dont know that think it has to go the "right way" so you can see the writing correctly.
Yea I could tell you knew ;-)I know, did you notice my smiley face? I will be noodling in the next 30 minutes. Can't wait. Dang all this rain over the last two weeks. Time to dig out the new chaps and gloves and go run this bad boy.
Enter your email address to join: