See if the threads are the same as one of the others and length also. Then is its the same screw sand the head on a bench grinder.Recently purchased an 044. It appears that one of the recoil bolts is wrong since the bolt head won’t fit in the counter sink. Lower right when looking at the recoil.
Does anyone have the correct part number for this?
View attachment 807881
It appears that one of the recoil bolts is wrong since the bolt head won’t fit in the counter sink.
Any idea on the thread pitch and diameter? Come to think of it I wasn’t going to buy a stihl part, just get a bolt that fits better.See if the threads are the same as one of the others and length also. Then is its the same screw sand the head on a bench grinder.
Thanks!For what it's worth, early 044's had M4 screws in the recoil.
Perfect - thanks.5mx20m
Well its 4 or 5 mm depending these guys are saying early ones are 4 can you measure it? Does it look the same as the ones that fit?Perfect - thanks.
Great question. Serial number is: 125453677From memory, I think the 10mm wrist pin saws can have either M4 or M5 in the recoil, M4 being in only the very early 10mm saws.... @mudfly is your saw a 10 or 12 mm?
Do you have other Stihl saws small ones?Great question. Serial number is: 125453677
Great question. Serial number is: 125453677
Well the smaller stihls commonly use 4mm screws for you to compare. Like on that pullstart cover.I do, but not immediately available where I am.
It isn’t a beauty queen. I’ll put some more pics up later.Don't be shy fly, show us the rest of the saw!!
Enter your email address to join: