cuinrearview
Red saw lover
I got this one with a broken crank. It had not been used very much. I built it from the cases up. The hole for the little rubber AV buffer behind the clutch was stripped, so I sourced a replacement case half. All OEM parts except Nachi main bearings and a caber ring. I've only ran this enough to tune it. Everything works and it runs great. Base gasket delete. Muffler is un-touched. New parts:
Crank bearings
Crank seals
Piston ring
372 intake clamp
Kitted HDA-199(idles great)
Air filter
Fuel line
I'm looking for $400 for the powerhead. Bars and chains available.
The top cover buckle that's missing in the picture has been replaced. This needs nothing, it's ready to go. If you want to make this your forever saw I have a spare OEM cylinder for your shelf for additional monies. Thanks for looking.
Crank bearings
Crank seals
Piston ring
372 intake clamp
Kitted HDA-199(idles great)
Air filter
Fuel line
I'm looking for $400 for the powerhead. Bars and chains available.
The top cover buckle that's missing in the picture has been replaced. This needs nothing, it's ready to go. If you want to make this your forever saw I have a spare OEM cylinder for your shelf for additional monies. Thanks for looking.