What would you guys run on a completely rebuilt Stihl 076 with an unlimited carburetor (runs up over 12,000 RPMs on the tach)? No plans to mill with it at this time. I'd like to use it for cutting bigger maples and pines around my property, as well as flush cutting larger stumps. 36" diameter trees is probably the biggest I'll run into. I'm running .404 7 pin sprocket. I believe I'd like either 25" or 30" Stihl bar with full chisel. Do you guys think 25" is too small for a tip top 076?
The biggest saw I run regularly is an 041 super with 20" bar, so I was going to take it easy and just run 25" to get used to weight of the thing (I believe 076 is about 5 lbs heavier than the 041 super). But if 30" is better suited to the HP and torque then I'd like to get that. Thanks.
The biggest saw I run regularly is an 041 super with 20" bar, so I was going to take it easy and just run 25" to get used to weight of the thing (I believe 076 is about 5 lbs heavier than the 041 super). But if 30" is better suited to the HP and torque then I'd like to get that. Thanks.