treeguyinoh
ArboristSite Operative
Hey guys, I have come up with a Honda 390gx for a song to use on a splitter, but the shaft is about an inch too long to mount to a direct couple mount. Cutting an inch of the shaft on the engine will do the trick, but i have never tried this before. So, instead of learning the hard way as usual, I thought I would ask you guys. Will this cause a problem? I can just reach with a vert. self feed bandsaw(Roll-In) with a lot of fixturing, but other than that, I am probably down to an angle grinder with a cutoff wheel. This seems like it may get a little hot on the oil seal. If anyone has ever tried this, please let me know. Thanks