Got a few of these in conditions ranging from basket cases to rebuilt runners. Prices are vary and are plus actual shipping.
Saw 1 (on the left) runner. Low hour saw, rebuilt bottom end. very clean. $300/OBO
Saw 2 (center) runner. First generation DCS6421 gray top Version. It's seen some hours and shows signs of use. $250/OBO
Saw 3 (right) runner. Clean saw with a stripped bar stud. $250/OBO (price goes up when I install the helicoil insert)
Saw 4 (not pictured) basket case. Orange and black saw, pretty clean...but The con rod bearing failed. Will need a crank, bearings, seals, gaskets, etc. project saw in pieces $150/OBO
The 20" bar goes with whichever one sells first.
Message me with any questions.
Saw 1 (on the left) runner. Low hour saw, rebuilt bottom end. very clean. $300/OBO
Saw 2 (center) runner. First generation DCS6421 gray top Version. It's seen some hours and shows signs of use. $250/OBO
Saw 3 (right) runner. Clean saw with a stripped bar stud. $250/OBO (price goes up when I install the helicoil insert)
Saw 4 (not pictured) basket case. Orange and black saw, pretty clean...but The con rod bearing failed. Will need a crank, bearings, seals, gaskets, etc. project saw in pieces $150/OBO
The 20" bar goes with whichever one sells first.
Message me with any questions.