Want to Sell Husky 181 with spares

[tolman_paul]

As much as it pains me to sell this saw, I haven't run it in a couple of years and don't see myself using it in the near future. It's a 181 with full wrap handle and 20" and 30" bars.

I've had the saw for almost 20 years and gave it an overhaul to replace the crank seals, vibration mounts, new oiler, fuel lines, rebuilt carb, new meteor piston and ring, muffler opened up and a port job. I can dig up the port durations, I went fairly conservative but it runs much stronger than stock. Also includes all items shown, spare oiler, spare carb, spare crank seals, spare clutch bell, spare drive sprockets, 20" and 30" loop of Stihl chain and other odds and ends as shown.

$400 plus shipping.

 

[tolman_paul]

Bump,

I'll pay shipping, $400 to your door.

 

[Toad22t]

If you could post some compression numbers. Some more close up pics including a pic of the piston would also help this saw sell. We all love picture's and it takes minimal time to help with the sale.

 

[Toad22t]

Ok now I just reread your post and seen that you added a new meteor piston.

 

[tolman_paul]

I should have known with this group lack of pictures equals last of interest. I recently moved and my compression tester and porting tools are MIA I think they might be buried behind Christmas ornaments under the stair well, but I'm not tackling that for another week. I only ran a couple tanks through the saw after the rebuild so compression should be strong. I ran it w/o the base gasket for a bit, but compression was so high it was tough to start.

 

[tolman_paul]

A few more

It's been a few years, but as I recall the port durations without the base gasket are exhaust 158 deg duration, transfer 118 deg duration and intake 156 deg duration.

 

[tolman_paul]

Sold pending funds