strtspdlx
ArboristSite Guru
I bought a fuel tank off an online auction site several months ago and it is an aftermarket tank. If I remember correctly it was from Hong Kong but I can't find the listing now. Anyway I put it on lastnight after tuning the saw to a good time with the factory tank. The factory tank was cracking around the trigger and I was afraid it was going to break in half at some point. So I put it on and now the saw runs dead rich even with the high and low screws turned out a max of 3/4 turn out from seated. And it won't quite idle. I'm assuming it would be the tank but I don't have a manual for the saw so I don't know how to pressure/vacuum test the tank. If someone could let me know the values that would be appreciated. I tried cracking the tank cap and didn't hear a hiss or see any signs of pressure build up. I tried blowing through the fuel supply line and it was letting pressure out of the bent but not much. It still had a buildup of pressure just pushing it through by breathing pretty much.
Regards-Carlo
Regards-Carlo