That's it!So it's just an electronic screwdriver attached to the H needle that constantly adjusts for best performance based on rpm in the cut?
That's it!So it's just an electronic screwdriver attached to the H needle that constantly adjusts for best performance based on rpm in the cut?
BingoSo it's just an electronic screwdriver attached to the H needle that constantly adjusts for best performance based on rpm in the cut?
Yes, that's the hours, the coloured bars are last run specs (WOT, load and idle).On the screen does it give you the total run time on the saw from new?
It looks like it does at the top of the screen or is that only while you have it hooked up to the program.
Has anyone else done just a MM and timed it before and after?
Thanks Randy. I was just checking my sanity, lol. Some saws it makes a big difference. Others, not so much.Same here.
And didn't really see that gains everyone said I would. lol
.................on a 555 or 562, lol.Lots of times
.................on a 555 or 562, lol.
Enter your email address to join: