Looking for clutch needle bearing part# for Husq. 350 with .500 dia pto side Raisman rimclutch

[9050lx]

I believe the 346/353 diameter is different for a clutch needle bearing ,not sure.The needle bearing on the saw is sloppy, I believe it is a stock size but AM, crappy fitting bearing as the clutch drum wobbles a bit.Converting it to rim sprocket so I wondered if anyone had the part# for an Oregon bearing.

 

[Chevboy0167]

https://www.ebay.com/itm/2538392326...9ff4e58:g:ziYAAOSwuANhSMUR&LH_ItemCondition=3

 

[9050lx]

Anyone know for sure if the clutch needle bearing crankshaft surface diameter is the same for the 346 as for the 350?

 

[Chevboy0167]

Well it uses the same bearing part number.... so must be the same inner diameter no??? 503 25 5201

https://www.partstree.com/models/346-xp-husqvarna-chainsaw-2007-02/clutch-drum-oil-pump-4/
https://www.partstree.com/models/350-husqvarna-chainsaw-2007-01/clutch-drum-and-oil-pump-6/

 

[9050lx]

I know.I bought what I thought was an Oregon clutch rim setup on ebay,was sent a Raisman, the needle bearing sent with the setup is too small to work,It was also said to work with 350 or 346.I used the old needle bearing off the spur sprocket and it is pretty loose.

 

[Chevboy0167]

https://www.ebay.com/itm/165143161240?epid=1701901095&hash=item26734ca998:g:P~gAAOSwAGVhcsra